I have also noticed some error messages when i boot linux related to the network driver: ath10k_pci 0000:02:00.0: firmware: failed to load ath10k/pre-cal-pci-0000:02:00.0.bin (-2)įirmware_class: See for information about missing firmwareĪth10k_pci 0000:02:00.0: firmware: failed to load ath10k/cal-pci-0000:02:00.0.bin(-2)Īth10k_pci 0000:02:00.0: firmware: failed to load ath10/QCA9377/hw1.0/firmware-6. Second step: Get the connected devices info by using the BSSID address that is retrieved from the first step as airodump-ng -band abg -bssid DC:FE. With channels switching, i have tried using 1 specific channel yet i found not ports with this solution either. First step: Get the BSSID address of the wifi adapter network by airodump-ng -band abg - wlan0 command. aireplay-ng -test wlan0 and aireplay-ng -test mon0 show injection is working. I believe this supports packet injection. airmon-ng shows my wireless card is an Atheros AR9462 using the ath9k - phy0 driver. This is important since before we proceed to change the mode, we need to kill. Im struggling to get a handshake from my router when using airodump. The next step in this procedure, is to take our wlan0 down. I have tried airmon-ng check kill but it didn't work, when i run airodump-ng, here's what i get: CH 12 ][ 19:23īSSID PWR Beacons #Data, #/s CH MB ENC CIPHER AUTH ESSID This will show us the mode of the wireless devices we have. (mac80211 station mode vif disabled for wlan0) (mac80211 monitor mode vif enabled for wlan0 on wlan0mon) Phy0 wlan0 ath10k_pci Qualcomm Atheros QCA9377 802.11ac Wireless Network Adapter (rev 31) (This will then put your wireless interface back up in monitor mode. It gives the following error: No such BSSID available. The card in monitor mode, they will interfere by changing channelsĪnd sometimes putting the interface back in managed mode Every time I try to use mdk3 d or even b, Kali cannot see the BSSID and asks for an ESSID. Kill them using 'airmon-ng check kill' before putting Kali Linux 2.0 Compatible USB Adapter Test and issue with RT3070 chipset may give perspective. Here's the airmon-ng output: airmon-ng start wlan0įound 3 processes that could cause trouble. I could not find anything with a clear solution, but the RT2870/RT3070 chipset appeared not to be compatible with the Linux kernel a year ago, and only had closed source drivers. I have a Qualcomm Atheros QCA9377 adapter that's integrated in my laptop (Dell Inspiron 15) and i'm running Kali Linux 64 2019.1 When I run airodump-ng to scan Wi-Fis around me, I get no output, like there's nothing around me.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |